Step drill steps on the cost!

Here is an interesting finding If in a CNC operation there is more that one step drill of the same size then using a plain drill and chamfer...

Read more »

Recycle XNAT inserts

Are you using XNAT inserts? These go on TaeguTec finish milling cutters in the name of INNOTOOL We have started recycling these with good re...

Read more »

Chip management

By Surendra Datar Tata Motors Limited Pune With auto loaders chip management becomes crucial and becomes difficult if the turning gets comb...

Read more »

Taper Milling? ------No, a good flat milling! Give it a try !!

By Surendra Datar Tata Motors Limited Pune Cylinder block and cylinder head contacting surfaces are demanding on quality w.r.t. flatness and...

Read more »

Do you have correct approach ?

We carry out fine boring of barrel bores of 6 cylinder and 4 cylinder engines on SPM as shown We found that the original tooling was use of ...

Read more »